Filter
Top Products
15
5. If alignment is necessary, loosen the two screws
(F) Fig. 18, align bracket (D) with the inner arbor
flange (E), and tighten screws (F).
6. Loosely assemble large washer and screw (C) Fig. 18,
to the inside splitter bracket. This screw and washer
was removed in STEP 3.
7. Assemble the blade guard and splitter assembly (G)
Fig. 19 between the large washer (C) and the splitter
bracket and tighten hex head screw (H) with 12mm
wrench.
8. Fasten the rear of the blade guard and splitter bracket
assembly (G) Fig. 20, to the rear splitter mounting
bracket using 5/16-18 x 5/8″ carriage bolt (J), 5/16”
flat washer and 5/16-18 hex nut. Align the hole in the
rear of the blade guard with the hole in the splitter
bracket. Insert the 5/16-18x5/8″ carriage bolt
through the holes. Place flat washer onto the bolt,
then place nut on bolt and tighten.
IMPORTANT: The splitter (G) Fig. 20, has a notch (L) cut
in the top edge. This feature will enable the blade
guard to stay in the raised position when the table
insert is removed to make blade changing easier.
Raise the front of blade guard (M) Fig. 21, until the
rear edge of the blade guard slips into notch (L) of
splitter (G); the blade guard will stay in this position.
ALWAYS RETURN GUARD DOWN TO
TABLE BEFORE OPERATING SAW. DO
NOT OPERATE SAW WITHOUT THE TABLE
INSERT AND GUARD IN PLACE.
Fig. 18
Fig. 19
Fig. 20
Fig. 21
C
D
F
G
H
C
GL
J
G
L
M
E