Filter
Top Products
21
MITER GAGE OPERATION AND
ADJUSTMENT
The miter gage is equipped with adjustable index stops at
90, 75, 60,45 and 30 degrees.
To rotate the miter gage, loosen lock knob (A) Fig. 40,
push the thumb lever (B) down and move the body of the
miter gage (C) to the desired angle.
The miter gage is equipped with a plate (D) Fig.41 which
fits into the T-Slot groove (E) in the table. This allows the
miter gage to be pulled off the front edge of the table
without falling. This allows for a longer cut-off capacity in
front of the blade.
Fig. 40
Fig. 41
MACHINE USE
COMMON SAWING OPERATIONS
Common sawing operations include ripping and crosscutting plus a few other standard operations of a fundamental
nature. As with all power machines, there is a certain amount of hazard involved with the operation and use of the
machine. Using the machine with the respect and caution demanded as far as safety precautions are concerned, will
considerably lessen the possibility of personal injury. However, if normal safety precautions are overlooked or
completely ignored, personal injury to the operator can result. The following information describes the safe and proper
method for performing the most common sawing operations.
THE USE OF ATTACHMENTS AND ACCESSORIES NOT RECOMMENDED BY DELTA MAY RESULT
IN THE RISK OF INJURY TO THE USER OR OTHERS.
A
B
C
D
E