Filter
Top Products
14
Fig. 27
Fig. 28
Fig. 29
Fig. 31
ADJUSTING 90 AND 45
DEGREE POSITIVE STOPS
FOR TABLE
1. Loosen table lock handle and move the table all the
way to the left and tighten table lock handle.
2. Using a square (A) Fig. 29, check to see if the table
is 90 degrees to the saw blade, as shown.
3. If the table is not at 90 degrees to the blade, adjust
the table accordingly, making certain screw (B) Fig. 30,
contacts bottom of table surface when table is 90
degrees to the blade. Screw (B) can be adjusted by
loosening nut (C), thread screw (B) in or out the desired
distance and tighten nut (C).
4. Tilt table all the way to the right, as shown in Fig.
31,
and tighten table lock handle.
5. Using a square (D) Fig. 31, check to see if the table
is 45 degrees to the saw blade, as shown.
6. If the table is not at 45 degrees to the blade, adjust
the table accordingly, making certain screw (E) Fig. 30,
contacts side of base when the table is at 45 degrees
to the blade.
TILTING THE TABLE
1. The table on your scroll saw can be tilted up to 45
degrees to the right for bevel cutting operations by loos-
ening table lock handle (A) Fig. 27. Tilt the table to the
desired angle and tighten lock handle (A). A scale and
pointer (B) Fig. 27, is provided to determine the angle of
tilt.
2. The table can also be tilted up to 15 degrees to the
left for bevel cutting operations by lowering the stop
block (C) Fig. 27, and tilting the table to the desired
angle, as shown in Fig. 28. Tighten lock handle (A).
Fig. 30
B
A
C
C
A
C
B
E
D