Filter
Top Products
5
Fig. 2
UNPACKING AND CLEANING
Your new scroll saw and stand is shipped complete in one container. Carefully unpack the saw, stand and all loose
items from the shipping container. Figure 2 illustrates the saw and all loose items and Figure 3 illustrates the stand
and all related parts. Remove the protective coating from the saw table surface. This coating may be removed with a
soft cloth moistened with kerosene (do not use acetone, gasoline or lacquer thinner for this purpose). After cleaning,
cover the table surface with a good quality paste wax. Buff out the wax thoroughly to prevent it from rubbing into
your workpieces.
1 - Scroll Saw
2 - Holddown Foot
3 - 1/2" Long Hex Socket Head Screw - for
fastening holddown foot to rod
4 - Lockwasher - for fastening holddown foot
to rod
5 - Flat Washer - for fastening holddown foot
to rod
6 - Table Insert
7 - 5mm Wrench
8 - 1-1/2" Long Hex Head Screws - for fas-
tening front of saw to stand (2)
9 - Flat Washers - for fastening front of saw
to stand (4)
10 - Lockwashers - for fastening front of saw
to stand (2)
11 - Hex Nuts - for fastening front of saw to
stand (2)
12 - 5/8" Long Hex Head Screws - for fasten-
ing rear of saw to stand (2)
13 - Lockwashers - for fastening rear of saw
to stand (2)
14 - Flat washers - for fastening rear of saw to
stand (2)
12
13
14
18
9
10
11
1
2
5
4
3
7
6