Filter
Top Products
7
Fig. 5
Fig. 6
Fig. 7
Fig. 8
3. Figure 8 illustrates the saw (H) fastened to
the stand (J). Place the stand on a level sur-
face and securely tighten all stand mounting
hardware.
2. Fasten the rear of the saw to the stand
using the two
5/8" long screws (F) Fig. 6, and lock washers
(G). The 5/8" long screws (F) are also shown in
Fig. 7, and are threaded up into the threaded
holes located on bottom of saw base.
FASTENING SCROLL SAW
TO STAND
1. Place scroll saw on top braces of stand
and fasten front of saw to top front brace
using the two 1-1/2" long screws (A) Fig. 5,
flat washers (B) and two flat washers (C), lock
washers (D) and hex nuts (E) from below.
B
A
C
B
A
D
E
H
J
G
F
F
F