Delta 46-460 Lathe User Manual


 
17
Fig. 35
RR
TT
UU
SS
10. Place new belt on spindle pulley making sure
grooves in belt align with grooves in pulley.
11. Place spindle pulley (RR) inside headstock (as
shown in Fig. 35) and hold as you insert the
spindle shaft (SS) through headstock and pulley.
Take care to align the shaft key (TT) with the
pulley keyway (not shown).
12. Be sure the pulley seats rmly against the shaft
shoulder (UU).
13. Tighten pulley set screw (QQ) Fig. 33 rmly.
14. Reinstall wave spring (PP) Fig. 32 and
handwheel (OO) Fig. 31. Handwheel tightens
counterclockwise. Tighten handwheel completely,
then back off 1/4 turn. NOTICE: DO NOT OVER
TIGHTEN. Doing so could damage the bearings.
15. Tighten two handwheel set screws (NN) Fig. 31
securely. With belt hanging loose, rotate spindle
to ensure it turns freely.
16. Lift belt tensioning lever (Y) Fig. 30 up and snap
it into place.
17. Check belt tension and adjust if needed. (See
Changing Pulleys section.)
18. Close pulley cover (X) Fig. 29 and side door
(AA) Fig. 16 securely.
19. Disengage indexing pin (FF) Fig. 31 if it was
engaged to remove spindle handwheel (OO).
To reduce the risk of injury, do not
operate lathe with pulley cover door open.
Do not turn on lathe with index pin
engaged. Doing so could damage the lathe.
REPLACEMENT PARTS
Use only identical replacement parts. For a parts list or to order parts, visit our website at
www.DeltaMachinery.com/service.
You
can also order parts from your nearest factory-owned branch, or by calling our Customer Care Center at 1-800-223-7278 to receive
personalized support from highly-trained technicians.
FREE WARNING LABEL REPLACEMENT
If your warning labels become illegible or are missing, call
1-800-223-7278
for a free replacement.
SERVICE AND REPAIRS
All quality tools will eventually require servicing and/or replacement of parts. For information about DELTA
®
Power Equipment
Corporation, its factory-owned branches, or an Authorized Warranty Service Center, visit our website at www.DeltaMachinery.com
or call our Customer Care Center at 1-800-223-7278. All repairs made by our service centers are fully guaranteed against defective
material and workmanship. We cannot guarantee repairs made or attempted by others.
You can also write to us for information at DELTA
®
Power Equipment Corporation, 99 Roush Street, Anderson, South Carolina
29625. - Attention: Product Service. Be sure to include all of the information shown on the nameplate of your tool (model number,
type, serial number, etc.)