Filter
Top Products
10
Fig. 13
LOWER COVER FOR SANDING DISC
Use three M4.2 x 13mm pan head screws (C) to attach
the lower cover (A) Fig. 13 to the belt and pulley guard
(B).
Prevent the sanding disc from contacting
the lower cover. Rotate the sanding disc by
hand to ensure that no contact is made.
C
NOTE:
Fig. 14
Fig. 15
SANDER TABLE
1. Insert the support rod (A) Fig. 14 into the hole in the
side of the sander until the rod (A) extends
approximately 5-1/2". Align the flat on the rod (A)
with the screw (B). Tighten the screw with the hex
wrench (C).
2. Slide the table assembly (D) Fig. 15 on the rod (A).
Align the flat on the rod (A) with the set screws (E).
Tighten the screws to hold table assembly (D) in
position.
To avoid trapping the work or fingers
between sanding disc and table, the
table edge (F) Fig. 15 should be
positioned a maximum of 1/16" away
from sanding disc (G). Loosen screws
(E) and adjust table accordingly.
D
F
G
E
C
Fig. 16
STARTING AND STOPPING SANDER
The switch (A) Fig. 16 is located on the sander base. To
turn the sander “ON”, move the switch to the up
position. To turn the sander “OFF”, move the switch to
the down position.
OPERATING CONTROLS AND ADJUSTMENTS
A
5-1/2"
A
B
A
B
C