Filter
Top Products
16
Fig. 39
Fig. 40
5. Place a new 6" x 48" sanding belt (F) Fig. 40 over
both sanding drums (G). Ensure that the belt will
travel in the direction of the arrows printed on the
inside of the belt.
6. Move the tension lever (E) Fig. 39 left to the
“TIGHTEN” position.
7. Replace the support bracket, backstop and upper
sanding drum guard, removed in STEPS 1 and 2.
8. Connect the electrical power to the sander. If the belt
is not tracking properly, refer to section “TRACKING
THE SANDING BELT.”
4. Move the tension lever (E) Fig. 39, to the right to the
“LOOSEN” position (F). Remove the sanding belt (F)
from both sanding drums.
F
E
G
G
F
REPLACING SANDING DISC
Fig. 41
1. Loosen the screw (A) Fig. 41, and remove the table
assembly (B).
2. Remove the three screws (C) Fig. 42 and lower the
cover (D).
3. Peel off the old disc (E) Fig. 43.
4. Make sure the disc plate (F) Fig. 43 is clean. Peel the
backing from a new sanding disc. Press the new
sanding disc firmly into position on the disc plate (F).
Replace the lower cover and table assembly,
removed in STEPS 1 and 2.
DISCONNECT MACHINE FROM POWER SOURCE.
Fig. 42
Fig. 43
A
B
C
D
E
F