Filter
Top Products
23
2. Loosen the two lock knobs (C) Fig. 68 enough to
allow the back panel (D) Figs. 67, 68, and 69 to
open.
NOTE: The lock knobs (C) cannot be removed.
3. Release the belt tension by turning the hand lever
(E) Fig. 67. Remove the belt (F) Fig. 69 from both
sanding drums.
4. Install the new sanding belt over both sanding
drums. Ensure that the belt runs in the direction of
the arrow, printed on the inside of the belt.
5. Turn the hand lever (E) Fig. 67 to apply tension to the sanding belt. Replace the top cover removed in STEP 2.
6. Close the back panel (D) Fig. 67. Tighten the two lock knobs (C) Fig. 68 that were loosened in STEP 3.
7. Check the belt tracking before applying power to the sander.
MAINTENANCE
REPLACING THE SANDING BELT
1. Loosen the two lock knobs (A) Fig. 67, and remove
the top cover (B).
REPLACING THE SANDING DISC
See the section “ABRASIVE DISC” in the “ASSEMBLY” section of this manual.
Disconnect the machine from the power source!
OVERLOAD PROTECTION
The motor supplied with your sander is equipped with a
reset overload relay button (A) Fig. 70. If the motor shuts
off or fails to start because of overloading (sanding too
heavy, using a worn sanding belt or disc, using the
sander beyond its capacity), or low voltage, turn the
power switch to the “OFF” position. Let the motor cool
three to five minutes and push the reset button (A) Fig.
70. Start the motor.
Fig. 68 Fig. 69
Fig. 70
Fig. 67
A
B
A
D
E
F
C
C
D
A
D
TROUBLESHOOTING
For assistance with your machine, visit our website at www.deltamachinery.com for a list of service centers or call the
DELTA Machinery help line at 1-800-223-7278 (In Canada call 1-800-463-3582).