Filter
Top Products
TABLE 1 COMPOUND MITER CUT (POSITION WOOD WITH BROAD FLAT SIDE ON THE TABLE
AND THE NARROW EDGE AGAINST THE FENCE)
SET THIS MITER ANGLE ON SAW
ANGLE OF SIDE OF BOX (ANGLE A)
SQUARE BOX
6-SIDED BOX
MITER DEGREE SETTING
BEVEL DEGREE SETTING
SET THIS BEVEL ANGLE ON SAW
INSTRUCTIONS FOR CUTTING CROWN MOLD-
ING LAYING FLAT AND USING THE COMPOUND
FEATURES
1. Molding laying with broad back surface down flat on
saw table (See Figure 30)
2. The settings below are for All Standard (U.S.) crown
molding with 52° and 38° angles.
BEVEL TYPE OF CUT
SETTING
LEFT SIDE,INSIDE CORNER:
Left 33.9° 1. Top of molding against fence
2. Miter table set right 31.62°
3. Save left end of cut
RIGHT SIDE, INSIDE CORNER:
Right 33.9° 1. Top of molding against fence
2. Miter table set left 31.62°
3. Save right end of cut
LEFT SIDE, OUTSIDE CORNER:
Right 33.9° 1. Top of molding against fence
2. Miter table set left 31.62°
3. Save left end of cut
RIGHT SIDE, OUTSIDE CORNER:
Left 33.9° 1. Top of molding against fence
2. Miter table set right 31.62°
3. Save right end of cut
When setting bevel and miter angles for all compound
miters, remember that:
The angles presented for crown moldings are very
precise and difficult to set exactly. Since they can easily
shift slightly and very few rooms have exactly square
corners, all settings should be tested on scrap molding.
PRETESTING WITH SCRAP MATERIAL IS
EXTREMELY IMPORTANT!
14
English
5
10
15
20
25
30
35
40
45
50
55
60
65
70
75
80
85
85
85
80
80
75
75
70
70
65
65
60
60
55
50
50
45
55
40
40
45
35
35
30
30
25
25
20
20
15
15
10
10
5
5
8-SIDED BOX
26.5˚
•
38˚