Filter
Top Products
English
4
Optional Accessories (Fig. 1)
The following accessories, designed for your saw, may be helpful. In some cases, other locally
obtained work supports, length stops, clamps, etc., may be more appropriate. Use care in
selecting and using accessories.
Extension, Work Support: DW7080
Used to support long overhanging workpieces, the work support is user assembled.
Your saw table is designed to accept two work supports; one on each side.
Adjustable Length Stop: DW7051
Requires the use of one work support. It is used to make repetitive cuts of the same
length from 0 to 42" (0–107 cm).
DW7084
DW7051
KNOBS
BRACKET
TOP HOLE
(USE FOR
DW716)
DW7082
END
PLATE
DW7080
LOCKNUTS
FIG. 1
Clamp: DW7082
Used for firmly clamping workpiece to the saw table for precision cutting.
Dust Bag: DW7053 (Included with some models)
Equipped with a zipper for easy emptying, the dust bag will capture the majority of the
sawdust produced (not shown).
Crown Molding Fence: DW7084
Used for precision cutting of crown molding.
Kerf Plate Blank: DW7055 (not shown)
Used to limit back side tear out of material or as a replacement kerf plate.
Miter Saw Stands: DWX723, DWX724, DWX725B (not shown)
Provides stable and accurate work platform for miter saws.
SAW BLADES: ALWAYS USE 12" (305 mm) SAW BLADES WITH 1" (25.4 mm) ARBOR
HOLES. SPEED RATING MUST BE AT LEAST 4800 RPM. Never use a smaller diameter
blade. It will not be guarded properly. Use crosscut blades only! Do not use blades designed
for ripping, combination blades or blades with hook angles in excess of 7 degrees..
BLADE DESCRIPTIONS
APPLICATION DIAMETER TEETH
Construction Saw Blades (thin kerf with anti-stick rim)
General Purpose 12" (305 mm) 40
Fine Crosscuts 12" (305 mm) 60
Woodworking Saw Blades (provide smooth, clean cuts)
Fine crosscuts 12" (305 mm) 80
Non-ferrous metals 12" (305 mm) 96
NOTE: For cutting non-ferrous metals, use only saw blades with
TCG teeth designed for this purpose.
IMPORTANT SAFETY INSTRUCTIONS
Unpacking Your Saw
Check the contents of your miter saw carton to make sure that you have received all parts.
In addition to this instruction manual, the carton should contain:
1. One No. DW716 or DW716XPS miter saw.
2. One D
EWALT 12" (305 mm) dia. saw blade
3. One blade wrench in wrench pocket shown in Figure 2.
4. One DW7053 dustbag (some models).
Specifi cations
CAPACITY OF CUT
50º miter left and right
48º bevel left and right
0º miter
Max. Height 3.6" (91.5 mm) Result Width 7.2" (183 mm)
Max. Width 7.9:" (200.7 mm) Result Height 2.9" (73.7mm)
45º miter
Max. Height 3.6" (91.5 mm) Result Width 4.9" (125 mm)
Max. Width 5.5” (140 mm) Result Height 2.9" (73.7 mm)
45º bevel - Left
Max. Height 2.3" (58.4 mm) Result Width 7.4" (188 mm)
Max. Width 7.9" (200.7 mm) Result Height 1.9" (48.3 mm)