Filter
Top Products
English
5
45º bevel - Right
Max. Width 7.9" (200.7 mm) Result Height 1.1" (28 mm)
Max. Height 1.6" (40.6 mm) Result Width 7.1" (180.3 mm)
Your saw is capable of cutting baseboard moldings 0.9" (22.9 mm) thick by 6" (152mm) tall
on a 45º right or left miter.
NOTE: Your saw is capable of cutting the following once a special set-up procedure is
followed (see Special Cuts).
0º miter height 1.5" (38.1 mm)
width 10" (255 mm)
45º miter height 1.5" (38.1 mm)
width 7.5" (190.5 mm)
DRIVE
120 Volt Motor
1675 Watts (max in) 15 Amp Motor
3800 RPM Cut Helical Gears
Multi-V Belt Roller Bearings
Automatic Electric Brake Carbide Blade
Familiarization
Your miter saw is fully assembled in the car ton. Open
FIG. 1A
the box and lift the saw out by the con venient carry ing
handle, as shown in Figure 1A. Place the saw on a
smooth, flat surface such as a workbench, strong
table or D
EWALT miter saw stand. Examine Figure 2
to become familiar with the saw and its various parts.
The section on adjus tments will refer to these terms
and you must know what and where the parts are.
CAUTION: Pinch Hazard. To reduce the risk of
injury, keep thumb underneath the handle when
pulling the handle down. The lower guard will move
up as the handle is pulled down which could cause
pinching. The handle is placed close to the guard for
special cuts.
TRIGGER
SWITCH
OPERATING
HANDLE
LEFT SIDE
FENCE
FENCE LOCK
KNOB
FENCE LOCK
KNOB
MOTOR
HOUSING
45º BEVEL
OVERRIDE
LEVERS
DUST
SPOUT
MOTOR END CAP
0º BEVEL
OVERRIDE KNOB
LOCK DOWN
PIN
BEVEL STOP
33.9º PAWLS
CARRY HANDLE
BLADE
WRENCH
45º
BEVEL STOP
ADJUSTMENT
SCREW
BEVEL LOCK
KNOB
HAND
INDENTATIONS
RIGHT SIDE
FENCE
MITER
LOCK LEVER
MITER SCALE
BENCH MOUNTING
HOLES
LOCK DOWN
PIN
BEVEL SCALE
0º BEVEL STOP
ADJUSTMENT
SCREW
FIG. 2
OPERATING
HANDLE
GUARD
KERF
PLATE
XPS
TM
ON/OFF SWITCH
(DW716XPS ONLY)
DW716