Filter
Top Products
Setting the Bevel Angle
When used with the guide rail, the blade of the TS 55 enters
the workpiece at exactly the same location regardless of the
bevel angle (see the picture on page 7). However, when used
without the guide rail, the cut position moves outward
slightly as the bevel angle increases. (The small notch at the
front of the sole plate indicates the cut position when the
saw is used without the guide rail.)
1. Remove the outrigger splinter guard.
2. Loosen the front and rear lock knobs.
3. Tilt the saw until the index pointer is pointed to the
desired bevel angle setting.
4. Tighten the front and rear lock knobs.
For bevel angles greater than 30 degrees, most of
weight of the saw is beyond the edge of the sole
plate. Make sure to hold the sole plate do
cutting to preve
the
wn when
nt the saw from tipping
unexpectedly.
Using the Guide Stop
The guide stop serves two purposes: it controls the saw’s
position and prevents a kickback during a plunge cut. The
leading edge of the guide stop prevents the saw from
moving backward as the plunge begins. The anti-kickback
lip engages with the sole plate of the saw to prevent the
back of the saw from lifting up at the beginning of a plunge
cut.
1. Slide the guide stop onto the T-slot of the guide rail with
the embossed arrow pointing toward the front of the
saw.
2. Position the stop behind the starting position of the saw.
► When the blade is at full-depth, the guide stop is 3 ¾
inches behind the start of the cut.
► When the blade is less than full depth, the distance
between the blade (cut) and the guide stop will be
greater.
► For best results, you should always verify the blade’s
cutting position before staring the cut.
3. Tighten the thumbscrew on the guide stop.
Instruction Manual 15