Filter
Top Products
Replacing the Guide Rail Gib Cams
26 TS 55 EQ Circular Saw
If the gib cams are over tightened, or the saw is used in an
environment with abrasive dust, the cams may develop flat
spots and should be replaced. Maintaining proper
adjustment and keeping the saw clean will increase the life
of the cams.
► Unplug the saw for safety, and lay the saw on its side on
a stable work surface.
► Using a T-15 Torx
®
driver, remove the screw that secures
each cam to the sole plate, and remove the cam and
friction washer.
► The replacement parts kit will
include 2-cams, 2-friction washers,
and 2-screws.
► Install the new cams and friction
washers with the screws provided.
► Make sure the limit tabs are
pointing away from the guide rail
slot as shown.
► Tighten the screws enough to
compress the friction washers, but
take care not to over tighten the
screws.
► Adjust the cams according to the procedure on page 8.
Replacing the Guide Rail Splinter Guard
The splinter guard prevents splintering and chipping of the
workpiece by holding the top edge of the workpiece down as
the teeth of the sawblade move upward against it. The
splinter guard needs to be replaced if it becomes damaged or
worn.
1. Peel the original splinter guard away from the guide rail.
2. As needed, clean residual adhesive and debris from the
guide rail.
3. Peel off the plastic backing from the new splinter guard
to expose the adhesive.
4. Without stretching the rubber, carefully place the new
splinter guard on the underside of the guide rail tight to
the alignment rib (14-b).
5. Make sure the splinter guard is firmly pressed down to
the guide rail.
6. Trim the splinter guard as described on page 8.