Filter
Top Products
9
PRGM
SET
Remote Control Programming
REMOTES
NOTE: THE REMOTE CONTROLS INCLUDED WITH THIS OPENER, HAVE
BEEN PRE-PROGRAMMED AT THE FACTORY FOR YOUR CONVENIENCE.
NOTE:
The following instructions are for remote control transmitters purchased
separately in addition to those provided with this opener, but
can also be used if any remote(s) may require re-programming.
NOTE:
Each programming step has a 30 second time limit for completion
after the function is initiated. After 30 seconds, two LED’s will illuminate RED
indicating time has expired and the step must be re-started. Restart the step as
many times as necessary to complete the programming.
NOTE:
Do NOT hold Remote too close to the Powerhead when programming
Remote buttons.
NOTE:
Each button on each Remote must be programmed separately,
following these steps.
1. Remove the battery’s protective lm from the remote by
pulling it straight out.
2. Press and hold the program button on the opener for two
seconds until the round LED turns blue, then release. The long
purple LED will ash.
Flashing Purple
3. Slowly press and release the remote button two times. The
opener LEDs will ash and go o, indicating it has been
successfully programmed to the remote.
4. Press and release the same button a third time and door will
open or close.
NOTE:
While programming remote buttons, stand at least 5 feet away from
the powerhead. This ensures you have proper communication between the
remote and the powerhead.
To program the same remote for other garage door openers, repeat
the steps above using one of the other remaining remote buttons.
REPEAT STEPS 1 TO 4 FOR EACH OPENER AND REMOTE
NOTE:
It is possible to press the remote button too quickly or lightly. If the
LEDs do not go o, press the remote button several more times to achieve
conrmation.
BASIC PROGRAMMING IS COMPLETE AND YOUR GARAGE DOOR
OPENER IS READY TO USE.
FCC and IC Certied
This device complies with FCC Part 15 and Industry Canada license exempt RSS standard(s). Operation is subject to the following two conditions: (1)
this devise may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of
the device. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular situation. If this equipment does
cause harmful interference to radio or television reception, which may be determined by turning equipment OFF and ON, the user is encouraged to try and correct
the interference by one or more of the following measures: (a) Re-orient or relocate the receiver antenna, (b) Increase the separation between the opener and
receiver, (c) Connect the opener into an outlet on a circuit dierent from that which the receiver is connected, and (d) Consult your local dealer. Any modication or
changes to this equipment which is not expressly approved by the manufacturer could void the user’s authority to operate the equipment.
This device complies with the Health Canada’s Safety Code. The installer of this device should ensure that the RF radiation is not emitted in excess of the Health
Canada’s requirement. Information can be acquired at: http://www.hc-sc.gc.ca/ewh-semt/radiation/cons/wi/index-eng.php
PRGM
SET