Genie 3022 Welder User Manual


 
5
Programming Overview
PRGM
SET
NOTE:
Before programming the operator, check to make sure
there are no objects in the garage door opening.
INTRODUCTION
Now that the garage door opener is installed, follow the
steps in this manual to program the opener so that the door
opens and closes properly and all remote devices operate
correctly. The following steps are a guide to setting opener so
it functions properly.
The following steps list the order of programming the opener’s
functional settings for use.
1. “TRAVEL LIMITS”
2. “FORCE and SPEED CONTROLS”
3. “REMOTE PROGRAMMING”
OVERVIEW OF POWERHEAD CONTROLS
This section describes the programming functions of the
opener. Use the following information to understand the
buttons, LED indicators and products used to program
functions.
Powerhead: There are 3 programming buttons and 2 LED
lights on the powerhead. Each of the buttons are used to enter
and complete the setup programming. The LED lights indicate
status or a function change by illuminating ON, OFF, or ON
FLASHING in one of three dierent colors: blue, red or purple.
There are 4 programs:
1. Door Travel Limits.
- This program is used to set how far the door travels
up and down.
2. Remote Programs (default menu)–only required for added
remote control transmitters.
- Describes how to program remotes to sync with
additional remote control devices, wall consoles,
keypads and the powerhead.
3. Force Setting Program.
- This program controls the force applied during the
closing and opening of the door. They are factory set
and will rarely require adjustment only under certain
circumstances.
4. Door Speed Program.
- This program does not require manually initiated
changes.
Term Denitions:
Travel Limits Programmable setting to adjust how far door
travels up or down.
Force Control refers to how much power is needed to
move (open/close) a particular door and does NOT require
programming.
Speed Control refers to how fast or slow the opener opens
and closes the door. This is factory set and does NOT require
programming. NOT available on all models.
Remote Programming synchronizes remote devices
(remote, wall console, and keypad) with the powerhead.
Moves door up or down during
programming and advance
through menus.
Enters into and selects
programming menus.
NOTE:
While setting limits, the powerhead has a 30 second time-out period when
none of the three programming buttons have been selected. If you see two solid red
ashing LEDs or if the LEDs ash red three times and then go OFF, you have run out of
time and must go back to the beginning of the travel limit setting step.
• Justremember—the pointed end of the button (like an arrowhead)
points in the direction the carriage will move when that button is
pushed.
DOOR
ORIENTATION
Standing under the opener’s powerhead – facing the door – looking up
– this is the view you will see of the programming buttons and LEDs.
Indicator LED’s
Up Travel
Down Travel
Programming/Menu
PRGM
SET
PRGM
SET
NOTE: The 3 programming buttons are for programming ONLY.
These buttons should NOT be used to operate the opener once the
Required Programming section has been successfully completed.