Filter
Top Products
13
Clearing Remotes
1. Press the PROGRAM/SET button on the powerhead and hold for
two seconds or until the round LED turns blue.
Steady Blue
CLEARING MEMORY OF REMOTES
2.ReleasethePROGRAM/SETbutton—roundLEDgoesoandthe
long LED ashes purple.
Flashing Purple
3. Press and hold the UP (+) and DOWN (–) button at the same
time, until both LEDs ash blue and go o.
Flashing Blue
NOTE:
Clearing memory of remotes from the powerhead will clear ALL
programmed remotes and wireless keypads. The opener will no longer
recognize any signal from any remote device, including a missing remote
device.
All remaining (or recovered) remotes and wireless keypads MUST be
reprogrammed as shown in pages 9,10,12.
4. To verify that the memory is cleared, press the remote key that
was previously programmed to the opener.
If the memory has been cleared the opener will NOT run.
If the remote is successfully cleared, the round powerhead LED will
ash blue when the remote button is pressed and the opener will not
operate.
NOTE:
The garage door opener will operate normally using the wall
console.
PRGM
SET
PRGM
SET
PRGM
SET