Filter
Top Products
11
Programming Wireless Keypad
(Continued)
Door Operation with Wireless Keypad:
To open and close a single door with the Keyless Entry Pad, enter
the PIN number and press Up/Down Key (enter).
For multiple doors enter the PIN number, press the UP/Down Key once
and enter the door number (1,2 or 3).
Mounting Keypad
The keypad MUST be mounted within sight of the garage door(s) at
least ve feet above the oor and clear of any moving door part.
1. Remove battery cover and batteries.
2. Drill 3/32” pilot hole for the top mounting screw (included).
3. Install a screw into the pilot hole, leaving a 1/8” gap between the
screw head and wall.
4. Hook the slotted mount, on back of keypad, over the screw.
5. Mark and drill a pilot hole for the bottom screw (included) and
secure keypad to wall (DO NOT overtighten).
6. Reinstall batteries and cover.
NOTE: The Keyless Entry Pad will stay active for 30 seconds and
will stop or start the door with each touch of any button on the
keypad.
Changing an Existing PIN:
1. Enter the current PIN
2. Press the Program key one time
3. Key in the new PIN (3-8 digits)
4. Press the Program key one time
NOTE:
Unlike “Resetting PIN,” there is no need to reprogram your
opener after changing the PIN.
Resetting a PIN:
Press and hold both the PROGRAM key and the Up/Down key
for about ve seconds.
The LED’s will slowly blink and then go out. When the LED stops
blinking, the old programming has been successfully erased.
To create a new PIN, start with “Setting the PIN for the First Time”