Filter
Top Products
17
Maintenance and Adjustments
Speed Adjustment
Speed Settings (DC motors only except 5042)
Speed settings are pre-programmed at the factory for the
maximum speed. Speed settings should not need adjustment
with this unit. However, travel speed for the opener can
be adjusted to a slower speed in both the Open and Close
directions, to minimize wear on heavier sectional doors.
There are three speed settings available for sectional doors.
Please note that speed may be aected by door weight and
balance, along with condition of door components and tracks.
Press and hold both up and
down arrow buttons until
round LED turns RED, release
buttons. Round BLUE LED will
ash 3 times.
LEDs will now display current UP force setting (See chart).
Press either arrow button until
desired UP force setting is
reached.
See Chart
Once setting is chosen, press
and release. This will lock the
UP force setting.
LEDs will now show current DOWN force setting. (See Chart).
Press either arrow button until
desired DOWN force setting is
reached.
See Chart
Once setting is chosen, press
and release. This will lock the
DOWN force setting.
The LEDs will now turn BLUE then o. This conrms
that both force settings have been set and unit is
ready for normal operation.
Repeat “Learn Force Limits and Contact Reverse Test” page 8
OFF
BLUE
BLUE
OFF
Flashes
3 Times
OFF
RED
BLUE
PRGM
SET
PRGM
SET
PRGM
SET
PRGM
SET
PRGM
SET
Resetting Travel Limits
See pages 6-7-8 to reset travel limits. Force setting and contact
reverse test must be performed in the event of a travel limit change.
NOTE: The opener will not close automatically unless the
Safe-T-Beam® System is installed and Limits are programmed.