Filter
Top Products
6
Additional safety rules for drill presses
Warning. For your own safety, do not try to use your drill
press or plug it in until it is completely assembled and
installed according to the instructions and until you have
read and understood the following:
1. Your drill press must be bolted securely to a workbench.
In addition, if there is any tendency for your drill press
to move during certain operations, bolt the workbench
to the floor.
2. This drill press is intended for use in dry conditions and
indoor use only.
3. Always wear safety goggles which comply to a
recognised standard. Use a face or dust mask along
with safety goggles if the drilling operation is dusty.
Use ear protectors, especially during extended periods
of operation.
4. Do not try to drill material too small to be securely
held. Do not drill material that does not have a flat
surface unless it is clamped securely.
5. Always keep hands out of the path of the drill bit.
Avoid awkward hand positions where a sudden slip
could cause your hand to move into the drill bit.
6. Do not install or use any drill bit that exceeds 175mm
(7 inches) in length or extends more than 150mm (6
inches) below the chuck jaws. They can suddenly bend
outwards or break.
7. Do not use wire wheels, router bits, shaper cutters,
circle (fly) cutters or rotary planers on this drill press.
8. When cutting a large piece of material make sure it is
fully supported at the table height.
9. Do not perform any operation freehand. Always hold the
workpiece firmly against the table so it will not rock or
twist. Use clamps or a vise for unstable workpieces.
10. Make sure there are no nails or foreign objects in the
part of the workpiece to be drilled.
11. Whenever possible, position the workpiece to contact
the left side of the column; if it is too short or the
table is tilted, clamp solidly to the table.
12. If the workpiece overhangs the table such that it will
fall or tip if not held, clamp it to the table or provide
auxiliary support.
13. Set the drill press to a speed appropriate to the job.
14. Do not start the drill press while the drill bit is
touching the workpiece.
15. When using a drill press vise, always fasten it to the
table.
16. Make sure all clamps and locks are firmly tightened
before drilling.
17. Securely lock the head and table support to the
column, and the table to the table support before
operating your drill press.
18. Never turn your drill press on before clearing the table
of all objects (tools, scraps of wood etc.)
19. Before starting the operation, jog the motor switch to
make sure the drill bit does not wobble or vibrate.
20. Let the spindle reach full speed before starting to
drill. If your drill press makes an unfamiliar noise or
if it vibrated excessively, stop immediately, turn the
drill press off and unplug it. Do not restart until the
problem is corrected.
21. Do not perform layout assembly or setup work on the
table while the drill press is in operation.
22. Do not exceed the rpm stated on the bit or accessory.
See the instructions that come with the accessory.
23. When drilling large diameter holes, clamp the
workpiece firmly to the table. Otherwise, the bit may
grab and spin the workpiece at high speed. Do not use
fly cutters or multiple-part cutters, as they can come
apart or become unbalanced in use.
24. Make sure the spindle has come to a complete stop
before touching the workpiece.
25. To avoid injury from accidental starting, always
turn the switch off and unplug the drill press before
installing or removing any accessory attachment or
making any adjustment.