Filter
Top Products
Overheating Protection
10 3A2587H
Overheating Protection
The motor has a built-in feature to protect itself from
overuse. If the motor stops, the thermal switch has
tripped. Do not return sprayer to store. The motor will
operate normally after cooling for 20-30 minutes.
For best results, do not spray more than one cup of
water through the tip while cleaning. If more flushing
is needed, remove the tip from the sprayer.
Sprayer Setup
This sprayer arrives from the factory with a small
amount of test material in the system. It is important
that you flush this material from the sprayer before
using it for the first time:
1. Fill material cup with water or compatible solvent,
thread onto sprayer and hand tighten.
2. Put prime/spray valve to UP position, then hold trig-
ger in for 10 seconds.
3. Put prime/spray valve DOWN to spray position.
4. Reverse spray tip to UNCLOG position and trigger
sprayer into a waste area for 10 seconds.
5. Engage trigger lock and put prime/spray valve UP to
release pressure.
6. Unscrew and remove material cup.
7. Disengage trigger lock, hold sprayer slightly above
material cup, and pull trigger to discharge fluid from
pump.
8. Discard material in cup.
Use only water-based or oil-based (mineral
spirit-type) materials with flash point greater than
100° F (38° C). Do not use materials which state
“FLAMMABLE” on the packaging. For more information
about your material, request MSDS from distributor or
retailer.
Use oil-based material outdoors or in a well-ventilated
indoor area with a flow of fresh air.
Keep spray area well-ventilated. Keep a good supply
of fresh air moving through the area.
NOTICE
Your sprayer is NOT compatible with harsh cleaners
such as chlorine bleach. Using these cleaners will
cause damage to the sprayer.
ti14992a
ti18915a
ti14999a
ti16700a
ti15425a
ti16701a
ti15491a
ti15012a
ti14777a
ti14999a
ti14994a
ti18912a
ti16700a
ti18919a