Filter
Top Products
Troubleshooting
26 3A2587H
Spray pattern is too narrow: Sprayer is too close to target surface. Move sprayer away from surface 10 in. (25 cm)
Incorrect spray tip for application of material. See Reversible Spray Tip Selection Chart, page 12.
Spray tip is worn or damaged. Replace spray tip. See Install Spray Tip/Guard
Assembly, page 13.
Spray pattern is too wide: Sprayer is too far away from target surface. Move sprayer closer to surface.
Incorrect spray tip for application of material. See Reversible Spray Tip Selection Chart, page 12.
Spray pattern “spits” at the end or
beginning:
Excess material has accumulated on spray
tip/guard assembly.
See Shutdown and Cleaning, page 15.
Spray tip filter is partially clogged or damaged. Clean or replace spray tip filter. See page 14.
Spray tip/guard assembly not threaded completely
onto sprayer.
See Install Spray Tip/Guard Assembly, page 13.
Seat is worn. Replace spray tip.
Spray tip continues to drip or ooze
material after trigger is released:
Needle assembly is worn out. Replace needle assembly.
Spray tip filter is partially clogged or damaged. Clean or replace spray tip filter. See page 14.
Spray tip/guard assembly not threaded completely
onto sprayer.
See Install Spray Tip/Guard Assembly, page 13.
Seat is worn. Replace spray tip/guard assembly.
Problem Cause Solution
ti15523a
ti15523a
ti15527a
ti15527a
ti15525a
ti15525a
ti15552a