Filter
Top Products
Storage
3A2587H 17
Cleaning Sprayer Exterior
• Wipe paint off outside of sprayer using a soft cloth
moistened with water or flushing fluid. Do NOT
submerge the sprayer. Do NOT use solvents with a
flash point greater than 100° F (38° C).
Storage
1. Lift valve UP to the prime position. Remove material
cup and flexible suction tube.
2. Remove child-resistent cap. Thread nozzle onto
Pump Armor bottle.
NOTE: For best results, make sure bottle is full.
3. Hold sprayer upside-down over a waste container.
4. Insert Pump Armor nozzle over material inlet and
push firmly until it stops. Squeeze cleaning bottle
until Pump Armor flows out drain tube.
5. Remove Pump Armor nozzle and replace
child-resistent cap and tighten securely for storage.
6. Attach flexible suction tube and material cup. Push
valve DOWN to spray position.
7. Store sprayer indoors in a cool, dry place. Store in
an upright position only. Never store sprayer with
material in the cup.
NOTICE
Failure to store sprayer with Pump Armor will result in
operational problems the next time you spray. Always
circulate Pump Armor through the sprayer after clean-
ing. Water or solvents other than mineral spirits
left in the sprayer will corrode and damage the
pump.
ti18922a
ti16700a
ti18916a
ti19034a
ti18067a
ti19424a
ti18066a
ti16700a
ti18069a
ti16701a
ti19423a
ti18915a
ti18921a