Filter
Top Products
Storage
3A2589D 17
Cleaning Sprayer Exterior
Wipe paint off outside of sprayer using a soft cloth moist-
ened with water or flushing fluid.
Use only water-based or
oil-based (mineral spirit-type) materials with flash point
greater than 100° F (38° C).
Do NOT submerge the
sprayer.
Storage
1. Lift prime/spray valve UP to the prime position.
Remove material cup and flexible suction tube.
2. Remove child-resistent cap. Thread nozzle onto Pump
Armor bottle. NOTE: For best results, make sure bottle
is full.
3. Hold sprayer upside-down over a waste container.
4. Insert Pump Armor nozzle over material inlet and push
firmly until it stops. Squeeze cleaning bottle until Pump
Armor flows out drain tube.
5. Remove Pump Armor nozzle and replace
child-resistent cap and tighten securely for storage.
6. Attach flexible suction tube and material cup. Push
valve DOWN to spray position.
7. Recharge battery to full charge before storage. See
Charging the Battery, page 6.
8. Store sprayer indoors in a cool, dry place. Store in
an upright position only. Never store sprayer with
material in the cup.
NOTICE
Failure to store sprayer with Pump Armor will result in
operational problems the next time you spray. Always
circulate Pump Armor through the sprayer after cleaning.
Water or solvents other than mineral spirits left in
the sprayer will corrode and damage the pump.
ti18879a
ti16700a
ti18870a
ti18869a
ti18067a
ti18862a
ti18066a
ti18177a
ti18069a
ti16701a
ti18871a
ti18872a
ti18885a