Filter
Top Products
Charging the Battery
6 3A2589D
Charging the Battery
Batteries are initially 50% charged to provide optimum battery
life and require charging before first use. It takes approxi-
mately 45 minutes to charge a dead battery to 80%, at which
point it can be used. It will take approximately 75 minutes to
fully charge a dead battery.
1. Place charger in a dry, well-ventilated area and away from
flammable or combustible materials, including paints and
solvents.
2. Plug charger into an electrical outlet and slide battery into
charger as shown (light will turn on in 5 seconds).
3. When battery becomes fully charged, immediately unplug
the charger from the power supply and remove the battery
from the charger.
NOTE: The amount sprayed with each battery varies depend-
ing on material, spray tip size, battery charge, and battery tem-
perature. One battery fully charged will spray up to one gallon.
Amount sprayed will be less depending on spray tip size,
material sprayed, life of battery, temperature, and other envi-
ronmental factors.
Charger Status Indicator Lights
NOTE: When the charger is plugged in, the charger status indicator lights will alternate between green and red several times
before they turn off, indicating that the charger is ready to charge a battery.
Sprayer Status Indicator Light
*NOTE: The sprayer status indicator light is only visible when sprayer trigger is engaged. You must squeeze and hold the trigger
to see the sprayer status indicator.
Replace and charge battery only in a well-ventilated area and
away from flammable or combustible materials, including
paints and solvents.
ti14990a
ti14990a
Label Appearance Description
Solid green light Indicates a full charge. Battery can be used.
Flashing green light
Battery is charging, indicates 80% charge.
Battery can be used.
Flashing red light
Battery is charging, indicates less than 80% charge.
Do NOT use battery.
Solid red light
Battery is too hot or too cold to charge. Remove battery and allow to cool or
warm up before charging.
Light* Appearance Description
No light Normal operation.
Solid red Battery is low on power and needs to be charged, or battery is too cold and
must warm up before spraying.
Flashing red Battery temperature is too high, or spray tip is clogged.
See Troubleshooting, page 27.
ti18884a