Graco XP70 Paint Sprayer User Manual


 
Initial System Setup
10 3A0420H
Initial System Setup
Complete the following steps in the order they are listed,
as they apply to your specific system, for initial system
setup.
1. Check the shipment for accuracy. Ensure you have
received everything you ordered. See Component
Identification, page 12.
2. Check for loose fittings and fasteners.
3. Install optional solvent flush pump kit 262393, if
ordered. See manual 310863 for instructions.
4. Mount and connect optional heaters, if ordered. See
the heater adapter kit manual 406861 for instruc-
tions and the heater manual 309524.
5. Install desiccant kits, if using polyurethane isocya-
nates in hoppers. See manual 406739 for instruc-
tions.
6. Install circulation and return tube kits if you are feed-
ing material from drums. See manual 309852 if you
are feeding urethane material.
NOTE: Supply return lines must be used.
7. Connect the feed pumps, fluid strainers, and air
hoses as necessary. If your sprayer does not use
hoppers, then see manual 312769.
8. Connect the air supply line. See Connect Air Sup-
ply, page 19.
9. Connect the fluid hose assembly, including the static
mixers, whip hose and gun. See Pressure Relief
Procedure, page 20.
10. Flush test oil from system as needed. See Empty
and Flush Entire System (new sprayer or end of
job), page 27.