Filter
Top Products
Setup
3A0420H 19
Connect Air Supply
1. Connect the air supply hose to the 3/4 npt(f) air filter
inlet (C).
NOTE: Use a 3/4 in. (19.1 mm) ID minimum air hose.
Air consumption is 75 cfm per gallon per minute
spraying. Do not use pin fitting type quick discon-
nects.
2. Remove plugs as necessary for solvent pump and
feed supply pump air hoses. See pump manuals for
setup instructions.
Connect Static Mixers, Gun, and
Hoses
1. Connect the outlet of the two primary static mixer
tubes, with mixer elements (W), to the fluid mix hose
(25), cleanup mixer (27, 28), whip hose (30), and
spray gun (31). See F
IG. 7.
2. Add mixed material hose as necessary between the
mix hose (25) and cleanup mixer (27,28).
Connect Fluid Hose Bundles
(Remote Only)
Connect additional fluid hoses to the fluid manifold (AA)
when the mix manifold (AB) is remote. Hoses must be
properly sized and balanced for your mix ratio. See mix
manifold manual for details.
1. Connect the resin and hardener hoses to the resin
and hardener outlets on the proportioner fluid mani-
fold and resin and hardener inlets on the mix mani-
fold.
NOTICE
To prevent creating a flare on the mixer tube, do not
use an union swivel end on the mix tube inlet.
C plug
r_571100_3a0420a_10a-1
FIG. 7
AN
25
W
27, 28
30
31
r_571100_3a0420a_43a
AB