Filter
Top Products
-32-
G0492 12" X 36" Combo Lathe/Mill
SECTION 5: MILL OPERATIONS
Figure 39. Start switch location.
Mill Spindle ON/
OFF Switch
It is essential to closely follow the proper break-in
procedures to ensure trouble free performance.
Complete this process once you have familiarized
yourself with all instructions in this manual.
To begin the start up procedure:
1. Make sure the mill has been properly lubri-
cated.
2. Make sure there are no obstructions around
or underneath the spindle.
3. Set the spindle speed to 240 RPM.
4. Turn the mill ON (Figure 39).
Failure to follow start up and spindle break-
in procedures will cause rapid deterioration
of spindle and other related parts, and never
shift gears while lathe or mill is running.
NOTICE
Test Run & Break-In
5. Turn the spindle ON and run it a minimum
of 10 minutes. Repeat this step on the other
three RPM ranges.
Figure 40. Gearbox and controls.
Milling Speed
Levers
Quill
Feed
Lever