Filter
Top Products
-24-
G0444/G0444Z 10" Table Saw
Install the Shop Fox
®
fence and rails according to
the fence manual.
Figure 28. Installed switch.
Components and Hardware Needed: Qty
Switch ................................................................1
Tools Needed:
10mm Wrench or Socket....................................1
To install the switch:
1. Remove the far left hex bolt that secure the
front fence rail to the fence bracket.
2. Using a 10mm wrench, secure the switch to
the fence rail with the hex bolt (Figure 28)
removed in step 1.
Components and Hardware Needed: Qty
Blade (Not Included) ..........................................1
Arbor Nut (Left Hand Threads) ..........................1
Arbor Flange ......................................................1
Tools Needed:
23mm Wrench ....................................................1
To install the blade guard:
1. Using a 23mm wrench, loosen the arbor nut.
Note—The arbor nut has left hand threads.
2. Remove the arbor nut and the arbor flange.
3. Slide the blade over the arbor. Note—Make
sure the teeth are pointing in the correct
direction (Figure 27).
4. Re-install the arbor flange and the arbor nut
and tighten them against the blade.
Figure 27. Correct blade direction.
Front Of Saw
Hex Bolt
Teeth Direction
& Blade Rotation
Switch
Fence Blade
!