Filter
Top Products
G0444/G0444Z 10" Table Saw -27-
Figure 35. Correct blade guard alignment.
8. Repeat steps 6-7.
9. Adjust the saw blade through its complete tilt
and height adjustments. The saw blade
should not make contact with any part of the
blade guard. If it does, re-adjust it as neces-
sary.
Proper
Alignment
Components and Hardware Needed: Qty
Standard Blade Table Insert ..............................1
Dado Blade Table Insert ....................................1
Tools Needed:
3mm Allen Wrench ............................................1
To install the table insert:
1. Place the table insert into the table.
2. Place a straightedge across the table and the
table insert.
3. Using a 3mm Allen wrench, adjust the table
insert flush with the table by rotating the
setscrews as shown in Figure 36.
Table Insert
Figure 36. Adjusting the table insert.