Filter
Top Products
-12-
G0460/G0461 12" Sliding Table Saw
Serious personal injury could occur if you
connect the machine to the power source
before you have completed the setup pro
-
cess. DO NOT connect the machine to the
power source until instructed to do so.
Full Load Amperage Draw
G0460 5 HP 220V 1-Phase ...................22 Amps
G0461 7.5 HP 220V 3-Phase ................20 Amps
G0461 7.5 HP 440V 3-Phase ................ 10 Amps
Circuit Requirements
We recommend connecting your machine to a
dedicated and grounded circuit that is rated for
the amperage given below. Never replace a circuit
breaker on an existing circuit with one of higher
amperage without consulting a qualified electri
-
cian to ensure compliance with wiring codes
. If
you are unsure about the wiring codes in your
area or you plan to connect your machine to a
shared circuit, consult a qualified electrician.
G0460 220V 1-Phase ..............................30 Amp
G0461 220V 3-Phase ..............................30 Amp
G0461 440V 3-Phase ..............................15 Amp
Minimum Cord Requirements
For 220V connection, we recommend using a
stranded-copper flexible cord that meets the
minimum criteria listed below, does not exceed
50 ft., and has an insulation type that starts with
"S." The exact insulation type should account for
any exposure to moisture, heat, and oils in the
working environment.
G0460 220V 1-Phase ...........10/3 AWG, 300VAC
G0461 220V 3-Phase ...........10/4 AWG, 300VAC
G0461 440V 3-Phase ...... Electrician to Hardwire
SECTION 2: CIRCUIT REQUIREMENTS
Figure 4. NEMA L6-30 plug and receptacle.
220V Plug/Connection Type
G0460 220V 1-Phase .................................L6-30
G0461 220V 3-Phase ............................... L15-30
Figure 5. NEMA L15-30 plug and receptacle.
Figure 6. Hardwired locking disconnect switch.
G0461 440V Connection to Power
Have a qualified electrician hardwire this machine
to a dedicated locking shut-off switch that is con
-
nected to the main power source.