Filter
Top Products
G0460/G0461 12" Sliding Table Saw
-37-
Crosscutting full size panels:
1. Install the crosscut fence in the forward
mounting points shown in
Figure 60 and lock
it in place.
2. Check to make sure the fence is at 90° and
adjust it as described in
Squaring Crosscut
Fence to Blade
on Page 47 if necessary.
3. Set either flip stop to the desired width-of-
cut.
4. Load the workpiece onto the table saw. The
setup should look similar to
Figure 57.
5. Once all the necessary safety precautions
have been taken, perform the cutting opera
-
tion.
Crosscutting smaller panels:
1. Install the crosscut fence in the rear mount-
ing points shown in
Figure 60 and lock it in
place.
2. Check to make sure the fence is at 90° and
adjust it as described in
Squaring Crosscut
Fence to Blade
on Page 47 if necessary.
3. Set either flip stop to the desired width-of-
cut.
4. Load the workpiece onto the table saw. The
setup should look similar to
Figure 58.
5. Once all the necessary safety precautions
have been taken, perform the cutting opera
-
tion.
Crosscutting using the rip fence as a
cut-off gauge:
1. Install the crosscut fence in the rear mount-
ing points shown in
Figure 60 and lock it in
place.
2. Check to make sure the fence is at 90° and
adjust it as described in Squaring Crosscut
Fence to Blade
on Page 47 if necessary.
3. Position the rip fence for the desired width.
4. Load the workpiece onto the table saw. The
setup should look similar to
Figure 59.
5. Slide the leading end of the rip fence behind
the back edge of the blade as shown in
Figure 61.
Figure 61. Correct rip fence position when using
it as a cut-off gauge.
6. Take all the necessary safety precautions,
then perform the cutting operation.
Figure 60. Crosscut fence mounting points.
Forward
Mounting Points
Rear Mounting
Points