Grizzly G0461 Saw User Manual


 
-26-
G0460/G0461 12" Sliding Table Saw
Figure 37. Set screws for adjusting riving knife.
7. Slide the table all the way forward to access
the blade arbor.
8. Loosen the flange bolt securing the lower
blade guard, slide the flange bolt up, and pull
open the lower blade guard.
9. Loosen the riving knife center bolt and remove
the riving knife.
10. Use the set screws shown in Figure 37 to
adjust the riving knife bracket, so the riving
knife aligns with the main blade when re-
installed.
5. Check the blade alignment on both sides of
the riving knife with a straightedge, as shown
in Figure 35.
—If the straightedge touches the riving knife
evenly on both sides, go to Step 5
.
—If the straightedge only touches the riving
knife on one side, go to Step 6
.
Figure 35. Checking riving knife alignment.
6. Place a machinist's square flat on the table
and slide it against the riving knife as shown
in Figure 36.
—If the square lies flat against the riving
knife, the riving knife is correctly adjusted
.
—If there is a gap between the square and
the riving knife, go to Step 6
.
Figure 36. Checking vertical alignment.