Filter
Top Products
-20- G0500/G1018/G1018HW 8" Jointers
To install the fence on the jointer unit:
1. Place the fence on the jointer unit as it was
before you removed it for clean up. Make
sure the key on the fence support lines up
with the keyway on the fence.
2. Install the fence lock the opposite way that
you removed it before clean up, with the han-
dle on top and the tabs of the nut facing up
as shown in Figure 22.
Fence to Jointer
To install the handwheels on the Model
G0500/G1018HW:
1. Remove the screw and washer from the end
of the leadscrew under each table, as shown
in Figure 23.
G0500/G1018HW
Handwheel Installation
Figure 22. Installing fence lock with the tabs on
the nut facing up.
Figure 23. Removing screw from leadscrew.
Figure 24. Installing handle into handwheel.
3. Lock the fence in place by tightening the
fence lock.
NOTICE
The fence can easily scratch the table while
you are adjusting the fence position. To
avoid scratches, loosen the fence lock
enough to permit an easy adjustment and
always use care when moving the fence.
2. On each leadscrew, install a handwheel, and
secure it with the phillips head screw and
washer that you removed in step 1.
3. Install a handle into each handwheel, as
shown in Figure 24.