Grizzly G0500 Biscuit Joiner User Manual


 
G0500/G1018/G1018HW 8" Jointers -21-
To assemble the knife setting gauge:
1. Insert the steel rod through the hole in each
adjuster arm until the notches for the E-clips
extend past the adjustment arms on both
sides.
2. Attach the E-clips to the notches to lock
adjustment arms onto the steel rod. The
adjustment arms are symmetrical, so the
placement is not a concern. See Figure 26.
Figure 26. Assembled knife setting gauge.
Knife Setting Gauge
To install the table levers on the Model
G1018HW:
1. Thread a table lever into the adjustment
block below each table, as shown in Figure
25.
G1018 Table
Lever Installation
Figure 25. Installing table lever into adjustment
block.
E-Clip