Filter
Top Products
-14-
G0528 Sliding Router Table
Components Needed: Qty
Left Fence .........................................................
1
Right Fence ........................................................
1
Dust Hood ..........................................................
1
Fence Lock Handles ...........................................
2
Tools Needed:
10mm Wrench or Socket ....................................
1
11mm Wrench or Socket ....................................
1
To attach the fence assembly:
1. Secure the left and right fence assemblies
to the table with the fence lock handles
.
Note—Use the holes located closest to the
edge of the cast iron table.
2. Secure the dust hood to the top of each
fence assembly (Figure 9
).
Figure 9. Installed fence and dust hood.
Dust Hood
Components Needed: Qty
Workpiece Hold-Down Assemblies ....................
2
Tools Needed:
19mm Wrench ....................................................
1
To attach the hold-downs:
1. Remove one of the hex bolts from each of
the hold-down brackets
.
2. Slide the hold-down brackets through the
mounting holes on the dust cover and secure
them from the underside of the dust cover
with the hex nuts removed in step 1
.
3. Tighten the hex nuts until the hold-down
brackets are secure.
4. Secure the hold-down finders to the hold-
down brackets by tightening the threaded
star knob (Figure 10). Note—Do not worry
about precise placement of the hold-down
brackets or fingers at this time.
Figure 10. Installed hold-down assemblies.
Workpiece Hold-
Down Assemblies
Threaded Star
Knobs
Hold-DownsFence