Filter
Top Products
-20-
G0528 Sliding Router Table
3. Raise the router bit to the desired height.
4. Adjust the fence back and away from the bit
only enough to allow the ball bearing to con
-
trol the depth of cut as shown in Figures 20
& 21
.
5. Adjust the fence as close as possible to the
bearing. The fence will serve as a back-up
support, reducing the chance of an accident.
Figure 20. Proper setup for profile cutting.
(Top View)
Figure 21. Proper setup for profile cutting.
(Side View)
Router Bit
Ball Bearing
Router Bit
Fence
Ball Bearing