Filter
Top Products
G0604 6" X 56" Jointer
-9-
Figure 1. NEMA 5-15 plug and receptacle.
Serious personal injury could occur if you
connect the machine to the power source
before you have completed the set up pro
-
cess. DO NOT connect the machine to the
power source until instructed to do so.
110V Operation
Grounding
In the event of an electrical short, grounding
reduces the risk of electric shock. This tool is
equipped with a power cord that has a grounding
wire, which must be properly connected to the
grounding prong on the plug; likewise, the outlet
must be properly installed and grounded. All elec-
trical connections must be made in accordance
with local codes and ordinances.
Amperage Draw
The Model G0604 motor draws the following
amps under maximum load:
Maximum Load ...................................... 13 Amps
Circuit Requirements
We recommend connecting this machine to a
dedicated circuit with a verified ground, using the
circuit size given below. Never replace a circuit
breaker with one of higher amperage without con
-
sulting a qualified electrician to ensure compli
-
ance with wiring codes
. If you are unsure about
the wiring codes in your area or you plan to
connect your machine to a shared circuit, you
may create a fire hazard—consult a qualified
electrician to reduce this risk.
Recommended Circuit Size ...................
15 Amps
Plug/Receptacle Type
Included Plug/Receptacle ................ NEMA 5-15
SECTION 2: CIRCUIT REQUIREMENTS
Electrocution or fire could
result if this machine is
not grounded correctly
or if your electrical con
-
figuration does not com
-
ply with local and state
codes. Ensure compliance
by checking with a quali
-
fied electrician!
Extension Cords
We do not recommend the use of extension
cords. Instead, arrange the placement of your
equipment and the installed wiring to eliminate
the need for extension cords.
If you must use an extension cord at 110V with
your machine:
• Use at least a 14 gauge cord that does not
exceed 50 feet in length!
• The extension cord must also contain a
ground wire and plug pin.
• Avoid cords over 50 feet long unless they
have been sized by a qualified electrician.