Filter
Top Products
G0604 6" X 56" Jointer
-39-
The infeed table on the Model G0604 has
positive stop bolts that, when properly set up,
allow the operator to quickly adjust the infeed
table between finish/final cuts and shaping/heavy
cuts.
We recommend setting the minimum depth of cut
to
1
⁄32" and the maximum depth of cut to
1
⁄8" for
most operations. DO NOT exceed
1
⁄8" cut per
pass on this machine or kickback and serious
injury may occur!
Each positive stop bolt (Figure 58) controls the
top or bottom range of the table movement. The
jam nuts lock the positive stop bolt in position so
it won't move during operation.
Setting Infeed Table
Figure 57. Using feeler gauge to set outfeed
table height.
6. Tighten the outfeed table lock located at the
front of the machine, and tighten the positive
stop bolts and jam nuts located at the back of
the machine (see
Figure 51).
7. Set the knife heights to the new outfeed table
height.
5. Place the straightedge on the outfeed table
so it hangs over the cutterhead, and lower the
outfeed table until the straightedge is 0.062"
(
1
⁄16") above the cutterhead body, as deter-
mined by using the feeler gauge or combina
-
tion of feeler gauges (see
Figure 57).
Figure 58. Positive stop bolts for infeed table.
Top Height
Bottom Height