Filter
Top Products
G0612 6" Jointer
-15-
Components and Hardware Needed: Qty
Dust Chute ........................................................
1
Dust Collection Bag ...........................................
1
Dust Bag Clamp ................................................
1
Phillips Head Screwdriver .................................
1
Dust Collection
The Model G0612 creates substantial amounts
of wood dust while operating. DO NOT oper
-
ate this machine without an adequate dust
collection system. Failure to use a dust col
-
lection system can result in short and long-
term respiratory illness.
Figure 19. Installing the dust chute.
5. Loosen the two jack screws, then, using a
scrap wood block, push the knife blade down
until both ends are sightly below the straight
-
edge.
6. Using the 4mm hex wrench, turn each jack
screw clockwise
1
/8
of a turn at a time until
each end of the knife touches the straight
-
edge evenly.
7. Rotate the cutterhead without disturbing the
knife clamp to check the knife height.
—If the knife moves the straight edge slightly
(
1
/8") forward and back on the table, the
knife height is set correctly.
—If the knife does not move the straightedge
slightly (
1
/8") forward and back on the table,
continue to make fine adjustments with the
jack screws until the knife is set correctly.
8. When the knife height is set correctly, firmly
tighten each of the knife clamp screws.
When the clamp is set firmly, tighten the jack
screws.
To Install the dust collection chute and bag:
1. Install the dust chute as shown in Figure 19.