Filter
Top Products
G0612 6" Jointer
-29-
Always disconnect power
to the machine before
performing maintenance.
Failure to do this may
result in serious person
-
al injury.
Cleaning the Model G0612 is easy and should
be done often. Vacuum excess wood chips and
sawdust, and wipe off the remaining dust away
with a dry cloth. If any resin has built up, use a
resin dissolving cleaner to remove it.
Protect the unpainted cast iron surfaces on the
table by wiping the table clean after every use—
this will help prevent moisture from wood dust
accumulating on bare metal surfaces.
Keep tables rust-free with regular applications of
products like G96
®
Gun Treatment, SLIPIT
®
, or
Boeshield
®
T-9.
SECTION 6: MAINTENANCE
For optimum performance from your machine,
follow this maintenance schedule and refer to any
specific instructions given in this section.
Daily Check
• Vacuum all dust on and around the
machine.
• Empty debris from the dust collection bag.
DO NOT use the jointer if debis obstructs the
flow of material into the bag. Using the jointer
when the chute is obstructed can lead to
jointer malfuction and, possibly, fire. Failure
to heed this warning can result in serious
personal injury.
• Wipe down tables and all other unpainted
cast iron with a metal protectant.
Monthly Check
• Fence angle stops and cutterhead knife
alignment.
• Belt tension, damage, or wear.
• Clean/vacuum dust from inside the cabinet
and around the motor.
Schedule
All bearings are sealed and permanently lubri-
cated. Do not lubricate them; leave them alone
until they need to be replaced.
Belts must be in good condition (free from
cracks, fraying and wear), and correctly adjusted.
Replacement belts can be ordered from Grizzly.
The part number for the cutterhead drive belt is
P0612070. The part number for the fan belt is
P0612092.
Belts
Cleaning
Lubrication