Filter
Top Products
G0622 4" X 6" Metal Cutting Bandsaw
-15-
Installing Pulleys
The V-belt drive system for the bandsaw requires
the installation of two pulleys. The pulleys are
covered for operator safety and to keep the V-belt
and pulleys clean.
Components and Hardware Needed: Qty
Pulley Cover ......................................................
1
Pulleys & Keys ...................................................
2
Phillips Head Screws M6-1 x 25 (installed) .......
2
Flat Washers 6mm (installed) ............................
2
To install the pulley cover:
1. KEEP BANDSAW UNPLUGGED!
2. Place the pulley cover over the motor and
gear shafts, and secure with the (already
installed) M6-1 x 12 Phillips head screws and
flat washers as shown in
Figure 10.
7. With the help of an assistant, lift the bandsaw
onto a pair of closely spaced sawhorses or
other suitable support (see
Figure 8).
Figure 9. Tool tray.
Figure 8. Leg assembly.
8. Attach the legs to the bandsaw with the M8-
1.25 x 20 hex bolts, flat washers, and hex
nuts.
Note: At this time, tighten with a 14mm
wrench or socket just enough to secure the
parts. F
inal tightening will take place when
the stand is fully assemble
d.
9. Remove the sawhorses and install the tool
tray in the middle of the stand as shown in
Figure 9 with M6-1 Phillips head screws, flat
washers and hex nuts.
10. Check to see if the bandsaw is relatively level
then final tighten all the nuts.
Figure 10. Installing pulley cover.