Filter
Top Products
-16-
G0622 4" X 6" Metal Cutting Bandsaw
To install the pulleys:
1. Open pulley cover.
2. Insert the woodruff keys into the slots on the
shafts.
3. Slide the large diameter motor pulley onto
the motor shaft, closest (
Figure 11).
Figure 11. Installing motor pulley.
Figure 12. Checking pulley alignment.
3. Install the worm gear pulley with the small
diameter wheel closest to the gear box.
4. Use a straightedge to check the alignment of
the pulley wheels as shown in
Figure 12.
Motor Pulley
with Key Slot
5. When the pulley wheels are aligned, tighten
the setscrews on both pulleys.
To install the V-belt around the pulleys:
1. KEEP BANDSAW UNPLUGGED!
2. Unthread the motor lock bolt to allow the
motor to pivot up.
3. Open the pulley cover door and pivot the
motor up to allow the V-belt to slide into the
pulley grooves as shown in
Figure 13.
Figure 13. V-belt installation.
Installing V-Belt
4. Release the motor, letting the weight tension
the V-belt, and thread the motor lock bolt
against the side of the bandsaw.
Motor Lock
Bolt