Filter
Top Products
G0622 4" X 6" Metal Cutting Bandsaw
-23-
Blade Guides
The blade guides should be as close to the
workpiece as possible. This will help ensure
straight cuts by keeping the blade from twisting
and drifting off the cut line.
To adjust the blade guides:
1. Loosen the knob shown in Figure 28 and slide
the blade guide as close to the workpiece as
possible, then tighten the knob.
Figure 28. Blade guides.
Blade Guides
Knob
The feed rate is controlled by the spring and
handle shown in Figure 29
.
To adjust the feed rate:
Slower: Twist the handle clockwise to add ten
-
sion to the spring.
Faster
: Twist the handle counterclockwise to
remove tension from the spring.
Feed Rate
Figure 29. Feed rate adjustment.
Spring
Handle