Filter
Top Products
G0622 4" X 6" Metal Cutting Bandsaw
-17-
Installing Work Stop
The work stop is designed to provide the operator
a quick reference for making multiple cuts at the
same length.
To install the work stop onto the bandsaw:
1. KEEP BANDSAW UNPLUGGED!
2. Install the work stop shaft into the side of the
bandsaw then lock it in place by tightening
the setscrew (see
Figure 14).
3. Slide the work stop onto the end of the shaft
and lock it into position with the locking lever
shown in
Figure 15.
Figure 14. Installing work stop shaft.
Figure 15. Work stop locking lever.
Locking Lever
Vertical Assembly
The Model G0622 can easily be set up for vertical
cutting operations.
Components and Hardware Needed: Qty
Table ...................................................................1
Table Bracket .....................................................1
Flat Head Screw
1
⁄4"-20 x
1
⁄2" ..............................1
Switch Safety Bracket ........................................
1
Hex Nut
1
⁄4"-20 ....................................................1
To assemble the bandsaw for vertical cut
-
ting:
1. Remove the two flat head screws and the
blade guide cover shown in
Figure 16.
2. Install the table and replace the two screws
removed in Step 1.
3. Install the table bracket shown in Figure 17
with the bolt (already in the casting), the flat
head screw, and the hex nut.
Figure 16. Blade guide cover.
Blade Guide Cover
Figure 17. Table and bracket installed.
Bolt Already
in Casting