Filter
Top Products
Ta i l s to c k
To position and lock the tailstock in position:
1.
Figure 12
2.
Note: The hex nut underneath the tailstock
may require occasional tightening to restore
proper clamping pressure and lever position.
When adjusted properly, the lever should be
at the horizontal position when the tailstock is
fully clamped to the bed.
Always operate the lathe with the tailstock
firmly locked to the bed. Otherwise, the
workpiece can be ejected causing serious
personal injury.
2.
Note: The hex nut underneath the tool rest
holder (Figure 13) may require occasional
tightening to restore proper clamping pres-
sure and lever position. When adjusted prop-
erly, the lever should be at the horizontal
position when the tailstock is fully clamped to
the bed.
Inboard Tool Rest
Positioning Inboard Tool Rest on
Bedway
1.
Figure 13
Always operate the lathe with the tool rest
holder firmly locked to the bed. Otherwise,
the workpiece can be ejected causing seri-
ous personal injury.
Figure 12.
Figure 13.