Filter
Top Products
Using Backing Block
Figure
36
Outboard Turning
Figure 37Installing
Faceplate/Handwheel Page 24
Keep the lathe chisel against the tool rest the
ENTIRE time you are cutting or when feeding
the chisel into the workpiece. Otherwise, the
spinning workpiece could knock the chisel
out of your hands or pull your hands into
the workpiece, resulting in serious entangle-
ment or impact injuries.
Figure 36.
To mount your workpiece to a backing block:
1.
2.
3.
4.
Note: Allow the glue to cure according to the
manufacturer's instructions.
5.
Figure 37.
Outboard Tool Rest Page 21
When outboard turning, rotate the workpiece
by hand before connecting the machine to
power to make sure that it will not come
in contact with any obstacle. Otherwise,
it could break apart during operation and
cause serious impact injuries.