Grizzly G0694 Lathe User Manual


  Open as PDF
of 60
 


Spindle Turning Safety Tips
 ON
    
    

 

      

Adjusting Spindle Speed Page
25
 




Faceplate Turning
       

     
     
Figure 34
Figure 34.
Mounting Workpiece on Faceplate
1.       Spindle
Turning Page 28
Note: Cut off corners of the workpiece to
make it as close to "round" as possible.
Figure 35.

NOTICE
Only use tap screws or wood screws with
non-tapered heads (Figure 35) to attach the
faceplate to the workpiece. Do NOT use dry-
wall screws or screws with tapered heads,
because they can split the faceplate or snap
off during operation.
2.       


3.       
    Headstock/
Faceplate Page 24  

 previous next