Filter
Top Products
3.
4.
5.
Figure 20
To prevent the workpiece from flying off dur-
ing operation, the faceplate MUST be firmly
threaded onto the spindle and secured in
place by fully tightening the four faceplate
set screws. If these instructions are not
properly performed, serious personal injury
could occur.
6.
Removing Faceplate or Handwheel
Installing Faceplate/
Handwheel
Faceplate Turning Page 30
Tools Needed Qty
Installing Faceplate or Handwheel
1.
2.
Figure 19
Always disconnect the lathe from power
before using the spindle lock feature. Never
resume turning operations without making
sure that the spindle lock is disengaged and
the spindle turns freely by hand. Otherwise
personal injury or property damage could
result.
Figure 19.
Figure 20.