Filter
Top Products
Model G0758 (Mfd. Since 2/14)
-17-
Figure 12. Example of a "Direct Mount" setup.
Machine Base
Workbench
Lag Screw
Flat Washer
Another option is a "Direct Mount" (see example
below) where the machine is secured directly to
the workbench with lag screws and washers.
Figure 11. Example of a "Through Mount" setup.
Assembly
Except for the handwheel handles, the mill/drill
was fully assembled at the factory.
Use a standard screwdriver to attach handwheel
handles (see Figures 13–14).
Figure 13. X- and Y-axis handwheel handles
attached.
Table Handwheel
Handles
Figure 14. Z-axis handwheel handle attached.
Vertical Handwheel Handle
Number of Mounting Holes ............................ 4
Diameter of Mounting Hardware .................
1
⁄2"
Bench Mounting
The base of this machine has mounting holes
that allow it to be fastened to a workbench or
other mounting surface to prevent it from moving
during operation and causing accidental injury or
damage.
The strongest mounting option is a "Through
Mount" (see example below) where holes are
drilled all the way through the workbench—and
hex bolts, washers, and hex nuts are used to
secure the machine in place.
Machine Base
Workbench
Hex
Bolt
Flat Washer
Flat Washer
Lock Washer
Hex Nut